Installation Method Of LED Strip Lights

- Nov 20, 2017 -

1, indoor installation: LED lights for indoor decoration, because of not having to undergo the installation is very simple so exposed to wind and rain. The LED lamp Guanghong electronic production zone as an example, behind each LED lamp belt are affixed with self-adhesive 3M double-sided adhesive, the installation can be directly off the surface of the 3M double-sided adhesive stickers, and then the lamp strip is fixed on the installation place, hand press flat is good. As for some places need to corner or long, how to do? Very simple, LED lamp band is composed of 3 LED as a series of parallel circuit structure, each 3 LED that can be cut alone use.

2, outdoor installation: outdoor installation will be subjected to wind and rain, if the use of 3M glue fixed, a long time will cause 3M stickiness decreased, resulting in LED light band off, so outdoor installation often use card slot fixed way. Where the shear and connection are required, the method is the same as the indoor installation, but only need to be equipped with waterproof glue to consolidate the waterproof effect of the connection point.

3, power connection method: LED lamp belt voltage is DC 12V, so need to use switching power supply, power supply according to the size of LED lamp belt and connection length to determine. If you do not want to take each LED lamp with a power to control, switching power supply can buy a relatively large power for the total power supply, then put all LED light with all input power in parallel (wire size is not enough, can also extend) unified by the total power switch. This advantage can be centralized control, inconvenient place is unable to achieve a single LED lamp band lighting effect and switch control, which specific way can be measured by their own.

4, controller connection: LED marquee belt and RGB lantern with all need to use the controller to achieve varying effect, while the control distance of each controller is not the same, in general, simple controller for 10 control distance to 15 meters, distance control remote controller is 15 to 20 meters, the longest can be controlled to a distance of 30 meters. If the length of the LED band is longer, and the controller cannot control the long band, then the power amplifier is needed.

5, pay attention to the LED lamp belt connection distance: Generally speaking, 3528 series of LED lamp belt, the connection distance is the longest 20 meters, 5050 series of LED lamp belt, the longest connection distance is 15 meters. If the connection distance is exceeded, the LED light band is easy to heat, and the service life of the LED lamp belt will be affected during use. Therefore, the installation must be in accordance with the requirements of the installation of manufacturers, should not let the LED lights with overload operation.


Related News

Related Products

  • PVC Rubber Round LED Truck and Trailer Light–4'' Tail/Stop/Turn Halo Lamp W/ 19 LEDs and Plug
  • Stainless Steel Shuttle Truck Clearance Light
  • Flush-Mount Round LED Truck and Trailer Light – 4'' Tail/Stop/Turn Light W/ 7 LEDs + Chrome Bezel
  • Flush-Mount Round LED Truck and Trailer Light – 4'' Tail/Stop/Turn Light W/ 15 LEDs + Chrome Bezel
  • Oval Oblong Side Marker Clearance Lamp Outline Light W/ Base Replacement Light for Bus Truck Trailer
  • 500A Long Battery Jumper Cables for Cars Trucks SUVs